|
Post by malavern on Oct 31, 2008 13:08:00 GMT 8
How to reinstall your rear slide... (though these steps in applied to basically everything else you'll want to do to your slide) - Remove slide from frame.
- Remove Spring Guide from frame.
- Remove Outer/Inner Barrel from frame.
- Remove Hex screw on back of Blow back unit.
- Pull sides of slide apart to remove blow back unit.
Now if you flip your rear sights over, you'll notice that it is uneven one side, usually the left, thats the bit that helps to hold the sights in place so it doesnt slide off sideways during operation. Insert the uneven (larger) side into the middle of the sight-placement hole, on top. then slide the rest of it into place. Once its in place, it should feel a bit loose, dont worry, as it'll become tighter once you reinstall the blow back chamber. therefore, follow the rest of the instructions. (Since all the parts are out in the open i'd recommend you to clean it up too. Especialy the inner barrel. make sure that it is COMPLETELY Dry, no silicon inside bothe the HopUp unit, and the barrel) - Insert blowback unit back into the slide.
- Screw in hex screw into rear of blowback unit to keep it in place.
- Insert Inner barrel into Outer barrel.
- Slide Outer/Inner Barrel assembly back into place.
- Reinstall Spring guide.
- Reset slide on frame.
You've reinstalled your Rear sight!! Note: If you want detailed lists on how to do other things, let me know. I'll post it up here too.
|
|